dinsdag 30 juli 2013
maandag 29 juli 2013
The Triumph Frame!
Now that's a job i seriously underestimated! I was thinking the sandblasting will take ap 8 hours of work. But with the thick layer of undercoat on the bottom of the frame i had to clean it all up before sandblasting! Another 4 hours of work surplus!
Anyway 90% of the frame is done now. just the front part where i have to reweld some rusted sections...
 |
| With the thick undercoat! |
 |
| Allmost complete degreased! |
 |
| Ready for sandblasting part II |
 |
| (lot's of) work in progress |
 |
| The result! |
donderdag 25 juli 2013
zaterdag 20 juli 2013
How to use a ball joint splitter!
 |
| I did not want to hammer mutch so with little help from the press the ball joint splitter did it's job! |
 |
| Ready for cleanup! |
woensdag 17 juli 2013
vrijdag 12 juli 2013
woensdag 10 juli 2013
Front wheel bearings
 |
| Press the old bearing out |
 |
| Add Grease nipple |
 |
| Add Grease nipple |
 |
| Old vs new (cleaned up) |
 |
| old vs new |
 |
| Ready for 2nd cleanup & Primer! :-) |
vrijdag 5 juli 2013
Steering - anti roll bar
 |
| mounting order of the steering rack |
 |
| Worn out , will replace with improved track rod ends (greasable!) |
 |
| mounting order of the anti roll bar (with worn out parts) |
Abonneren op:
Reacties (Atom)